b'Open the Arduino IDEConnect the RedBoard to a USB port on your computer. Open the Sketch:File > Examples >SIK-Guide-Code-master > CIRCUIT_1B-POTENTIOMETER Select UPLOAD to program the sketch on the RedBoard.W H AT Y O U S H O U L D S E EYou should see the LED blink faster or slower in accordance with your potentiometer. The delay between each flash will change based on the position of the knob. If it isnt working, make sure you have assembled the circuit correctly and verified and uploaded the code to your board. If that doesnt work, see the Troubleshooting section.PROGRAM OVERVIEW1 Read the position of the potentiometer (from 0 to 1023) and store it in the variablepotPosition .2 Turn the LED on.3 Wait from 0 to 1023 milliseconds, based on the position of the knob and the value ofpotPosition .4 Turn the LED off.5 Wait from 0 to 1023 milliseconds, based on the position of the knob and the value ofpotPosition .6 Repeat.22 : circuit 1b'