b'TROUBLESHOOTINGMake sure that your 5V, A0 and GND pins are properly The potentiometer always connected to the three pins on your potentiometer. It is reads as 0 or 1023easy to misalign a wire with the actual pot pin. Make sure that you have selected the correct baud rate, No values or random9600.Also ensure that you are on the correct serial characters inport. The same serial port you use when uploading Serial Monitor code to your board is the same serial port you use to print values to the Serial Monitor.Youve completed Circuit 1B!Continue to circuit 1C to learn about photoresistors and analog to digital conversion.BLINKINGREADING AREADING A AN LED POTENTIOMETER PHOTORESISTOR RGB NIGHT-LIGHTA B C D25 : circuit 1b'