b'TROUBLESHOOTINGMake sure your LED is oriented in the right direction. If the LED One of the LEDs isnt still doesnt work, try wiggling the resistor and the wires that lighting upconnect to the LED.The buzzer is too loud Turn the potentiometer to adjust the volume.or too quietCarefully check your wiring for each button. One leg of the One of the buttons isntbutton should connect to a pin on the RedBoard; the other leg workingshould connect to the ground rail on the breadboard. Make sure they are declared correctly. Make sure you dont have 5V and GND mixed up. Double check None of the buttons or that you have a GND connection from the RedBoard to the GND LEDs are workingrail on the breadboard.Jumper wires unfortunately can go bad from getting bent too much. The copper wire inside can break, leaving an open connection in your circuit. If you are certain that your circuit is Still not working?wired correctly and that your code is error-free and uploaded, but you are still encountering issues, try replacing one or more of the jumper wires for the component that is not working.Youve completed Project 2!Continue to Project 3 to explore using servos and sensors.DIGITAL BUZZER TRUMPET SIMON SAYS GAMEA B C52 : circuit 2c'