b'TROUBLESHOOTINGMake sure all of your servo wires are connected. Be sure that the black wire is connected to the negative The servo doesnt work rail and the red wire is connected to the positive rail. Make sure you are using a digital pin that is capable of PWM.The two lines of code that pass angles to the servo The pop-up is moving too muchmotor are myservo.write(45); and myservo.or not enough write(135);. Try changing these angle values to fine-tune your mechanism.Youve completed Circuit 3C!Continue to Project 4 to learn how to use an LCD in your circuits.DISTANCE SERVO MOTORS SENSOR MOTION ALARMA B C70 : circuit 3c'